Reply to thread

You could try something similar to what this guy did for fibreglassing his B9:


http://www.b9robotbuildersclub.com/pub/old/LISD/B9Torso.html


... was thinking of something similar for spray painting as I'm also short of undercover outside facilities. I've got a small shed, but I find that the wind still picks up the dirt and bits get stuck in the paint.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top