Reply to thread

If you plan on using the OB1 tutorial,and making the PVC frame,and using the "Great Stuff" expanding foam it will be more than enough support for the jet pack.I suppose fiberglass will work,but you don't want to do any damage as mentioned with the heat from the fiberglass curing.Just looking out for you  :)




Steve


This thread is more than 23 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top