Reply to thread

Thanks Chief ! :D


I remember that ! What an awesome trip that must have been. If I remember right, you guys got to go to the "Ranch" too !


I met Don at CIII actually. We chit chatted for a bit but he was in charge of the prop exhibit so he had to take care of biz. But from the short amount of time I had with him I could tell he was just an awesome guy !


And a couple of people have already asked about what kind of "shell" this is going in. I made the accurate ROTS 3 piece helmet years ago but some may not remember it. As I already said, there has just never been enough interest in this piece, but  I should have already posted a pic of it for those that have no clue what's going on - on the outside :lol: Here is what the interior contents fit into :





FP


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top