Reply to thread

When you put a new battery in and flip the power switch (the one in the middle that flips up and down) do any of the small leds on the micro controller ( the small blue circuit board) come on? The green one should come on and stay on and the red one will flash for a second or two when you power the kit up then it will go out.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top