Reply to thread

Message

Ah, well I'm making the 1:1 at £70 which is 3 layers of resin and a fiberglass layer plus postage at the mo. I doubt the femme one will be any more expensive and probably cheaper.

What's the height of the vinyl in inches?

The head size I am making it for depends on the answers I get here, I have a male noggin, so I am a bit stumped as to what size I should make the helmet. I was looking at taking 2 inches off the 1:1, is that too much or too little?

[QUOTE="Saz, post: 267840, member: 3401"] Ah, well I'm making the 1:1 at £70 which is 3 layers of resin and a fiberglass layer plus postage at the mo. I doubt the femme one will be any more expensive and probably cheaper. What's the height of the vinyl in inches? The head size I am making it for depends on the answers I get here, I have a male noggin, so I am a bit stumped as to what size I should make the helmet. I was looking at taking 2 inches off the 1:1, is that too much or too little? [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification