Reply to thread

What Necronaut said.  I did the same set up just this Tuesday.  Used velcro to hold the fans in & put a longer strip on the inside of the helmet to allow for some moving of the fans if need be.  Also mounted the battery pack on the left rear of the helmet next to the key slot recess to keep the helmet balanced some.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top