Reply to thread

I can't verify that the perspex are the same or different in thickness, but will say that they are clearly hand cut so there are differences.


Also, I think it is highly unlikely that the drill holes or drain of wheat bulbs would be different from helmet to helmet.  There might be slight variances in the perxpex, but I would tend to believe those aspects are the same.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top