Reply to thread

Message

That's it. So on the PP2 the aluminium foil isn't there...
Because you have the wires running into the Perspex block powering the grain of wheat bulbs, when the adhesive strip fails, as seen on the ESB hero, the only thing preventing the block falling out are those wires. This is why the narrow end of the block has slipped out, revealing that aluminium backing sheet.

[QUOTE="terminal fettler, post: 357284, member: 1151"] That's it. So on the PP2 the aluminium foil isn't there... Because you have the wires running into the Perspex block powering the grain of wheat bulbs, when the adhesive strip fails, as seen on the ESB hero, the only thing preventing the block falling out are those wires. This is why the narrow end of the block has slipped out, revealing that aluminium backing sheet. [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification