Reply to thread

latest update. I decided to go back to the dome and reshape the rear section. A lot of sanding and priming later, I'm much happier. Also started on the earpieces and nearly done with them. I've also pinched in the nose and secured that, hence the cracks in the cheeks. I need to hollow out the cheeks a bit more but it's getting there. I've had a couple of friends ask me about making helmets for them so I think I might try my hand and casting this one. Anyone know where the best suppliers of silicone and casting resins are in the UK. I've had a look at Smooth-on in the US but I can't order directly from them. Some help would be cool! Any comments welcome in general on the bucket. Cheers everyone.:cheers


[ATTACH=full]19331[/ATTACH]


[ATTACH=full]19332[/ATTACH]


[ATTACH=full]19333[/ATTACH]


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top