Reply to thread

Yeah, the welder's face shield is pretty pliable; that's what gave me the idea in the first place.  It's real thin plastic, but sturdy enough to use for visor material.


Here's an updated diagram:




Can you tell I have nothing better to do at work?   :)


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top