Reply to thread

Yes sir I have. That was my plan. But my problem is I cant free hand worth a darn. I thought I would draw them out on the styrene then cut out and glue. I just cant get size or look right.

I was thinking if I have a template, I could use that to cut out the pcs.

 

If there is a better way, I am all for it. I have been working on this all weekend and I am a little numb to the whole thing. Better ideas are welcome.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top