Reply to thread

I think you'll be fine with a basecoat of aluminum.........I had good success going that route. Besides there is alot of final weathering of a light gray,rust,black wash needed to be done to the whole helmet upon completion that the Panzer Yellow will tone down even more.

 

 

I was also wondering the same about acrylics being mixed with enamels,but that's what the RS tips said ;)


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top