Reply to thread

Message

They are actually Revell engine parts, a pully if I recall.
The V-8 conecting rod sits on the flare of the receiver and the other end sits on a rear pully Revell # 104 or 107.

I used the details that I received from WOF and scratch-built some out of some 3mm black pvc tabe. I cut, shaped, sanded, stacked and painted several layers.

[QUOTE="Prymer13, post: 98979, member: 267"] They are actually Revell engine parts, a pully if I recall. The V-8 conecting rod sits on the flare of the receiver and the other end sits on a rear pully Revell # 104 or 107. I used the details that I received from WOF and scratch-built some out of some 3mm black pvc tabe. I cut, shaped, sanded, stacked and painted several layers. [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification