Reply to thread

I used 12ga. solid core for the top white wire.


I used a black cord from an old VCR and wrapped it with red electrical tape for the middle "red" wire.

 

I used the same black cord for the bottom black wire.

 

The bottom two red/black looked fatter than the top most white wire to me so I used what I thought the prop makers might have had on hand :)

 

Steve


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top