Reply to thread

Thanks!


Setting up the printers this afternoon to run one, just want to double-check the blaster's fitment in the holster so it rides securely at the correct depth. Perfect would be for it to sit in it's seat unbuckled without any 'wiggle', but still holstering and unholstering smoothly.  (y)


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top