ESB EE-3 screw sizes for assembly

Thread starter pucksdown
Start date Oct 27, 2018

pucksdown

Jr Hunter

Oct 27, 2018

I'm in the process of 3d printing an ESB EE-3. (Have completed a 3d print jetpack..will post pics later)... I'm looking for the screws sizes to use for assembly.

I want it to be somewhat functional where it can...ie..trigger, hammer etc.

Looks like post screws are ideal but I'm looking for sizes.

Any input is appreciated!

Thanks

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.