Reply to thread

RafelFett, thanks for sharing your 3-D model. I found a local 3-D printer and had two made up. With some light sanding and a fine dremel tool, I was able to remove most of the scan lines and have updated my Fett blaster.


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top