Reply to thread

Here are some updates from John a couple weeks ago.


The rangefinder stalks were all drilled in one go and from only one end (top down).  Pretty impressive.


[ATTACH=full]196099[/ATTACH]


And another update from last week.  John has been working on re-drawing the final "original drawings" on the proper draftsman's paper while on vacation.


[ATTACH=full]196100[/ATTACH]


[ATTACH=full]196101[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top