Reply to thread

OPPI - Sorry, yes I do agree :)


But If you want to suck every last ounce of brightness from the LED, you could go as low as just one 330 Ohm resistor,I do it a lot. I wouldn't do it if it were NOT a blinker. Since it is a blinker, the blinking keeps the constant load off of the LED. But Fetthunter's suggestion is the way to go for most applications.


Chris


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top