Reply to thread

if they're sintra, you could countersink a rivet and fill it over smooth.  If your using fiberglass and strengthened the inside with an aluminum strap you could attach it to that before you epoxy the aluminum in.  You could use a snap and epoxy half to the inside.  Plenty of ways.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top