Reply to thread

Message

I purchased the padded insert from Fenix Props on Ebay. It gives a nice finished look to the helmet.

I placed some extra foam on the rangefinder side so it does not tilt on the stand or if you want to wear/ display.

The insert itself is nice. But needs to be glued or velcroed in. I've had it over a year now but have not committed to gluing it in yet.

[QUOTE="clonecollector, post: 524435, member: 2361"] I purchased the padded insert from Fenix Props on Ebay. It gives a nice finished look to the helmet. I placed some extra foam on the rangefinder side so it does not tilt on the stand or if you want to wear/ display. The insert itself is nice. But needs to be glued or velcroed in. I've had it over a year now but have not committed to gluing it in yet. [/QUOTE]

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification