Reply to thread

The metal parts of the webley should resemble blued steel which on my real one is a grey/blue satin finish.  Some folks seem to think it should be bronzey, maybe cos many other flare guns are made of bronze or brass.  I found Revell #9 anthracite or RAL7021 a good match to my original's finish  A very light gun metal drybrush over the top, slightly heavier on the edges gives a good representation.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top