Reply to thread

Hum, i see what you mean.

To be honest i don't have any pictures to confirm that but i'm convinced they should be hollow just like the original found part is. If they had done a mold and resin casts of them, they would certainly have replaced the one which fell from the blaster during filming which isn't the case.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top