Reply to thread

Took about 6 hours to build (not counting dry times)












Parts used to make this:


Sidewinders Resin cast of the original gun (he also provided the  pvc tube for the front barrel, the muzzle, the pvc rings in the middle, and the scope blocks)


Scope by Braks Buddy


F4 greeb by Asok


Stock greeb's by Ebay


T-Track by www.blast-tech.com


Bondo/CA/Squadron putty, black and gray Krylon spray paint, styrene.


Rust effects achieved with "RustAll" - highly recommend if you want that "rusty" look.  www.rustall.com



Steps of assembly -


Glue it together, patched the holes, seams, made the "ridge" greeb for the middle, primer coat (gray primer), then spray black.


after drying - used rustall to rust it.


Still have to zap it with dull coat - but I'm going to add some more detail dirt.



Thanks for all the inspiration and help on this project - TDH rules!


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top