Reply to thread

Second attempt, made the mask from a thinner plate and no it fits and curves perfectly.


[ATTACH=full]135453[/ATTACH]


[ATTACH=full]135454[/ATTACH]


[ATTACH=full]135455[/ATTACH]


[ATTACH=full]135456[/ATTACH]


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top