Reply to thread

Made a first 3D cardboard mockup of the mask. Overall not bad and definitely the look I’m going for.

 The next mockup will be shrunk to 95% of what it is now. The helmet looks too small compared to the mask now.

Also the nose part will be more narrow.


[ATTACH=full]135443[/ATTACH]



[ATTACH=full]135444[/ATTACH]



[ATTACH=full]135445[/ATTACH]



[ATTACH=full]135446[/ATTACH]



[ATTACH=full]135447[/ATTACH]


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top