Reply to thread

Now lets move onto finishing the chest box.

[ATTACH=full]120874[/ATTACH]

Take the black print and color print and glue them together. Make sure they register correctly.

Then glue them into the light box from the back with them black print facing out.

*I FORGOT TO PHOTOGRAPH THIS*

Now place the silver tape along the top and side walls of the inside of the light box.

Also add the silver tape to the white piece of plastic. This will serve as the back cover for the

light box.

*I FORGOT TO PHOTOGRAPH THIS*

Hot glue the lights with the on/off switches facing toward the back.

Tape the plastic piece to the box. The tape along the top will act as a hinge covering the light box.

Your box should now be done!

[ATTACH=full]120875[/ATTACH]

[ATTACH=full]120876[/ATTACH]

[ATTACH=full]120877[/ATTACH]

[ATTACH=full]120878[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top