Reply to thread

[ATTACH=full]114883[/ATTACH]



[ATTACH=full]114884[/ATTACH]



[ATTACH=full]114885[/ATTACH]



Next step i used a hardener to fill the cooler part,this gives the effect of the cooler as a solid look.


[ATTACH=full]114886[/ATTACH]



[ATTACH=full]114887[/ATTACH]



[ATTACH=full]114888[/ATTACH]



Next was to use the filler to fill the rear part of the blaster, then sand off to a smooth finish.


[ATTACH=full]114889[/ATTACH]



[ATTACH=full]114890[/ATTACH]



[ATTACH=full]114891[/ATTACH]



Next step was the Power cell, this proved to be the most challenging part of the the build, i used 3mm ply wood, made a rough box shape.


[ATTACH=full]114892[/ATTACH]



More to follow.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top