Reply to thread

Get flat black and espresso (both krylon).  Stand a few feet back and spray (in bursts) above the helmet.  It will fall on it and dirty it up a bit.  Then, dull coat it with Krylons matte gloss.  As long as you stand back far enough (this will have to be determined by you), you will be fine.


Then, black wash the whole thing.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top