Finally worked on the resin lineage Westar-34 blasters. Almost finished with them, just need to add some metal screws in place of the resin cast mock screws and add a trigger guard on the right blaster.
I first used a dremel to remove the sprues on each blaster followed by sanding (a lot of sanding) and then painted with a gray primer. I then wet sanded with a fine grit and went over each blaster with very fine steel wool.
The grips were painted with a medium gray and all of chrome parts were done with Rub'n Buff. Lastly I drilled the 6 little holes in the "hammer" of each blaster, glued a bronze o-ring at the end of the "flash hider" and added the brass pins.
[ATTACH=full]246434[/ATTACH]
[ATTACH=full]246429[/ATTACH][ATTACH=full]246430[/ATTACH][ATTACH=full]246431[/ATTACH][ATTACH=full]246433[/ATTACH]
