Reply to thread

Message

I am in the process of a new outfitand I need to make a small hole into finished fiberglass. I am very nervous as I do not want to ruin or crack the finish.

How should I do this? I was thinking of placing a few layers of masking tape on the finished side of the armor and using a tiny drill bit on the dremel make the hole. Then using gradual sizes of drill bits, keepon working on the hole until I get the right size.

Hopefully, the masking tape will preotect the finish and it won'tcrack.

Any thoughts orideas would be MOST welcomed.

[QUOTE="Jedi Bob, post: 146097, member: 42"] I am in the process of a new outfitand I need to make a small hole into finished fiberglass. I am very nervous as I do not want to ruin or crack the finish. How should I do this? I was thinking of placing a few layers of masking tape on the finished side of the armor and using a tiny drill bit on the dremel make the hole. Then using gradual sizes of drill bits, keepon working on the hole until I get the right size. Hopefully, the masking tape will preotect the finish and it won'tcrack. Any thoughts orideas would be MOST welcomed. :) [/QUOTE]

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification