Reply to thread

Message

hey guys/gals,

This is only my second post to the forum but I have been following it for several weeks now but I have a question for some of you vets out there.

I have found a DP 96 bucket at a local flea market...been through the wringer had a 2 inch crack on the left cleak and slightly distorted.

I was wondering if anyone could give me the correct measurements for this specific bucket so i can line it back out and put a new visor in.
I just dont know the how far the mandbiles are supposed to be apart or how big the span of the bottom of the bucket should be. Here is a paint drawing that I am gonna try to explain what i am trying to say...lol.

The white lines represent my problem areas that I am not sure about....I would appreciate any advice you guys could give me.

Thanks!

John

[ATTACH=full]4254[/ATTACH]

<blockquote data-quote="Jedi killa 73" data-source="post: 73979" data-attributes="member: 1243">hey guys/gals,&nbsp;This is only my second post to the forum but I have been following it for several weeks now but I have a question for some of you vets out there.&nbsp;I have found a DP 96 bucket at a local flea market...been through the wringer had a 2 inch crack on the left cleak and slightly distorted.&nbsp;I was wondering if anyone could give me the correct measurements for this specific bucket so i can line it back out and put a new visor in. I just dont know the how far the mandbiles are supposed to be apart or how big the span of the bottom of the bucket should be.&nbsp; Here is a paint drawing that I am gonna try to explain what i am trying to say...lol.&nbsp;The white lines represent my problem areas that I am not sure about....I would appreciate any advice you guys could give me.&nbsp;Thanks!&nbsp;John[ATTACH=full]4254[/ATTACH]</blockquote>

[QUOTE="Jedi killa 73, post: 73979, member: 1243"] hey guys/gals, This is only my second post to the forum but I have been following it for several weeks now but I have a question for some of you vets out there. I have found a DP 96 bucket at a local flea market...been through the wringer had a 2 inch crack on the left cleak and slightly distorted. I was wondering if anyone could give me the correct measurements for this specific bucket so i can line it back out and put a new visor in. I just dont know the how far the mandbiles are supposed to be apart or how big the span of the bottom of the bucket should be. Here is a paint drawing that I am gonna try to explain what i am trying to say...lol. The white lines represent my problem areas that I am not sure about....I would appreciate any advice you guys could give me. Thanks! John [ATTACH=full]4254[/ATTACH] [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification