Reply to thread

Message

To reshape my helmet I used the "metal rod" as well. Its not actually a mental rod. It is a metal ring that is used for sewing/crochette (SP?). You can find them at Michael's. I used a Dremel and cut the ring in half so that it would fit inside the back of the helmet where it was needed. I heated the helmet and used a glue gun to attach the metal ring. Worked like a charm.

Here are some pics of the finished product...

http://members.cox.net/debnwar/helm5.JPG
http://members.cox.net/debnwar/helm6.JPG

[QUOTE="Duh, post: 37593"] To reshape my helmet I used the "metal rod" as well. Its not actually a mental rod. It is a metal ring that is used for sewing/crochette (SP?). You can find them at Michael's. I used a Dremel and cut the ring in half so that it would fit inside the back of the helmet where it was needed. I heated the helmet and used a glue gun to attach the metal ring. Worked like a charm. Here are some pics of the finished product... [url="http://members.cox.net/debnwar/helm5.JPG"]http://members.cox.net/debnwar/helm5.JPG[/url] [url="http://members.cox.net/debnwar/helm6.JPG"]http://members.cox.net/debnwar/helm6.JPG[/url] [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification