Reply to thread

Im going throught the same thing myself. Ive heard of some people installing a metal rod around the bottom rim of the helmet. Im gonna try doing the same thing but with some slim aluminum extrusion. Im just wondering if CA glue would hold it in place. Otherwise, i guess it could be screwed on with a few screws and then putty in the screw heads. Im gonna work on it tonight and see how it works out. I'll let you know.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top