Reply to thread

The ol' clock method actually worked out nicely. Dom actually just reminded me that I even used this method back then, I must be in the status of 'old fart' :lol:. It's just finding the right clock that will work, and going on VEEERRY low speed drilling a hole in the clear plastic, because you can easily crack it. But take your time, and you actually get a nice, clean little display :)


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top