Reply to thread

Message

Has anyone done exact measurements of the gauntlets? What I mean is width, hieght, elevation hieghts of the different components. Ive seen on different threads that the exact demensions of the dental expander is known and someone who is better with computers than I could use this as the key (like a map) on varied pictures to get the exact demensions. Simple algebra/geometry I think would do it. I beleive enough of the components on the gauntlets are known that this might be pulled off quit easily. If this has already been done, please refer me to it, and ignore my simple ramblings.

[QUOTE="tteF aboB, post: 6356, member: 154"] Has anyone done exact measurements of the gauntlets? What I mean is width, hieght, elevation hieghts of the different components. Ive seen on different threads that the exact demensions of the dental expander is known and someone who is better with computers than I could use this as the key (like a map) on varied pictures to get the exact demensions. Simple algebra/geometry I think would do it. I beleive enough of the components on the gauntlets are known that this might be pulled off quit easily. If this has already been done, please refer me to it, and ignore my simple ramblings. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification