well, i gave it a shot. it went ok, not good, not bad, just ok. after practicing on some scrap pieces i ended up doing about half the dents. i was able to do the dents on the outer edges of the armor, but the ones inside of the armor i found very difficult and wasn't getting the results i wanted. the trash can plastic is rather tough to get to a soft enough point all the way through without getting wonky on the visible side. so, instead of ruining what i have, i just did the outside stuff, and will fake the rest with paint/weathering. i got the primer and base coat of aluminum down and will snap some pics tomorrow after work when it's totally dry. if you ask me, i would recommend trash can armor for jango, but maybe not boba. at least for a beginner like me.
