Reply to thread

ok, i'm a sucker for peer pressure.:p  i'll try the denting again. i don't have a heat gun though. are there other recommended methods i can try without having to buy something? i'll ask around the 'hood and see if i can find one. i'll retry the hair dryer in one spot. i was moving it around a bit, maybe that was the problem. if that doesn't work i'm thinking of turning the oven on and holding the portion of each piece to be dented up near the heating element. hopefully without melting it too far. any other suggestions?


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top