Reply to thread

I used the end of a round lightsaber hilt for the larger dents, and for the smaller dents I found some sort of thing in the living room that was on 3 balls for legs, I flipped it upside down and pressed the sintra down onto it.


You're using plastic though, it may be a little harder to dent than sintra.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top