Reply to thread

Message

I used a heat gun making all my armor from scratch. Just wear gloves and push your thumb into the armor or some sort of tool so that you dent it. The plastic won't stick to the screwdriver unless you've melted the plastic too much. You shouldn't be melting it to the point that its smoking. If you do, you've gone too far and your also risking health problems. Styrene releasing cancer causing fumes if you heat it to the point of smoking.

[QUOTE="webchief, post: 4902, member: 26"] I used a heat gun making all my armor from scratch. Just wear gloves and push your thumb into the armor or some sort of tool so that you dent it. The plastic won't stick to the screwdriver unless you've melted the plastic too much. You shouldn't be melting it to the point that its smoking. If you do, you've gone too far and your also risking health problems. Styrene releasing cancer causing fumes if you heat it to the point of smoking. [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification