Reply to thread

How thick is the plastic?  You can add dents with a dremel if the plastic is thick enough.  You can also hold the plastic over a candle and let a hot spot form, which will sink down a bit under it's own weight.  You run the risk of ruining it.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top