Reply to thread

Actually - it's now a $120 vac table... 'cause i decided on doing a different method for the support bars... i bought some punched angle iron strips that'll go on the outside each corner... this way i don't have to have the notches in the tray and the plastic... i'll show pix when i swap the bars out to explain what i mean :)


yo Joe... what'z up :) Jace and I have a project in mind ;)  plus I need it for a project I'm working on for www.mrfrothy.com


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top