Reply to thread

Hey Jason- WOW...Great info! You guys are a huge help! Id like more detailed info on the whole sanding and primer info...im not the most handy guy but im sure I can manage and dont mind the project at all! On the cape, it just clips into the clasps, and the chain is a decoy that sits on the front correct? creating the illusion that its held by the chain alone??? And to clear this up, the outside section is velcrod to the lateral shoulder bells to help keep in place. I actually have one set that I experimented with that have 3" risers on bottom and 1" inside the boot...they dont look to bad at all. I have another pair being done w/ only 2" on bottom and 1" inside which only puts me at 6'1" or 6'2"? Any suggestions? Did you have to use risers at all?

Thanks

Brian


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top