Reply to thread

Message

If I may ask, Andy, how did you attach the T Tracks? Double-sided tape or epoxy of some sort? Did you do any special filing of the ends that cover the end cap?

I've picked up a resin cast of a correct shroud from Sidewinder. I am a bit hesitant to drill into it though for fear of breaking through where I am not intending. Nevertheless, all that to say, I will likely begin a temporary build soon and have been going back and forth about attaching the T tracks in the most non-permanent way. Any advice is greatly appreciated.

I say non-permanent as this MPP is destined for non-Vader usage ultimately.

[QUOTE="Mugatu, post: 394043, member: 7215"] If I may ask, Andy, how did you attach the T Tracks? Double-sided tape or epoxy of some sort? Did you do any special filing of the ends that cover the end cap? I've picked up a resin cast of a correct shroud from Sidewinder. I am a bit hesitant to drill into it though for fear of breaking through where I am not intending. Nevertheless, all that to say, I will likely begin a temporary build soon and have been going back and forth about attaching the T tracks in the most non-permanent way. Any advice is greatly appreciated. I say non-permanent as this MPP is destined for non-Vader usage ultimately. [/QUOTE]

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification