Reply to thread

Message

Started sanding the helmet today. Haven't started the bondo work but I've got an industrial size thing of it waiting to be cracked open. It's going ok for now, focused on the face today, but it's gonna take time. Cut the eyes out but don't have all of my dremel bits to get the rest, so it looks kinda goofy at the moment. Gonna start bondo tomorrow...

[ATTACH=full]82153[/ATTACH]

[ATTACH=full]82154[/ATTACH]

[ATTACH=full]82155[/ATTACH]

-TC

[QUOTE="tubachris85x, post: 103627, member: 1226"] Started sanding the helmet today. Haven't started the bondo work but I've got an industrial size thing of it waiting to be cracked open. It's going ok for now, focused on the face today, but it's gonna take time. Cut the eyes out but don't have all of my dremel bits to get the rest, so it looks kinda goofy at the moment. Gonna start bondo tomorrow... [ATTACH=full]82153[/ATTACH] [ATTACH=full]82154[/ATTACH] [ATTACH=full]82155[/ATTACH] -TC [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification