Reply to thread

Message

Got some more work on the sculpt last night, started to focus on the lower face area. If you compare, I've narrowed both sides of the upside down "U" shape, and have begun sculpting the greeblie in the middle. Unfortunatly, the greeblie detail from my references is only clear enough on the top portion, while everything below that is just "black" and any detail lines are non-existant or noticable. Because of this, I'm forced to interperete the rest of it, so I cannot say that this piece will be accurate. It still needs alot of clean up work though, and I'm thinking about making this a seperate piece until I make the final mold.

[ATTACH=full]82092[/ATTACH]

[ATTACH=full]82093[/ATTACH]

Just a side profile to get a better feel of the shapes

[ATTACH=full]82094[/ATTACH]

-TC

<blockquote data-quote="tubachris85x" data-source="post: 103518" data-attributes="member: 1226">Got some more work on the sculpt last night, started to focus on the lower face area. If you compare, I&#039;ve narrowed both sides of the upside down &quot;U&quot; shape, and have begun sculpting the greeblie in the middle. Unfortunatly, the greeblie detail from my references is only clear enough on the top portion, while everything below that is just &quot;black&quot; and any detail lines are non-existant or noticable. Because of this, I&#039;m forced to interperete the rest of it, so I cannot say that this piece will be accurate. It still needs alot of clean up work though, and I&#039;m thinking about making this a seperate piece until I make the final mold.[ATTACH=full]82092[/ATTACH][ATTACH=full]82093[/ATTACH]Just a side profile to get a better feel of the shapes[ATTACH=full]82094[/ATTACH]-TC</blockquote>

[QUOTE="tubachris85x, post: 103518, member: 1226"] Got some more work on the sculpt last night, started to focus on the lower face area. If you compare, I've narrowed both sides of the upside down "U" shape, and have begun sculpting the greeblie in the middle. Unfortunatly, the greeblie detail from my references is only clear enough on the top portion, while everything below that is just "black" and any detail lines are non-existant or noticable. Because of this, I'm forced to interperete the rest of it, so I cannot say that this piece will be accurate. It still needs alot of clean up work though, and I'm thinking about making this a seperate piece until I make the final mold. [ATTACH=full]82092[/ATTACH] [ATTACH=full]82093[/ATTACH] Just a side profile to get a better feel of the shapes [ATTACH=full]82094[/ATTACH] -TC [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification