Reply to thread

Hmm...I'm not exactly sure what you mean? I'm assuming the vents? For that, I just took a metal vent panel from home depot, cut the strips out, and then used a flat piece of styrene in the proper shape, layed the strips over it, bent the ends over the edge of the styrene and used hot glue to hold it down


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top