Reply to thread

If the spike on the back gets heavy you could brace it with something. Then patch over the resulting hole in your silicone mold when you pull it off. Just something to keep in mind.


Yea I figured it would be a slushcast, but I consider a slushcast and a rotocast to be basically the same.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top