Reply to thread

If your concerned about the foam head tipping you could run some long rods into a ply-wood base and the ram the head onto the rods. I don't think you would have to worry about its weight pulling on the foam. If nothing else you can make a partial spike out of foam and then coat it in clay.


Are you going to be vacuum forming the helmet or rotocasting it?


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top