Reply to thread

Message

Well in the mock up in the old pic above with the face taped to the buck, the dome fits it correctly. In the begining, I use the original FX back piece, and use the base measurements, as well as the curve to help establish where the dome would sit. So the dome fits everything. Once I start the clay, I should be able to help "meld" the pieces together, so that it will all just flow with each other...

I need sleep...

[QUOTE="tubachris85x, post: 103201, member: 1226"] Well in the mock up in the old pic above with the face taped to the buck, the dome fits it correctly. In the begining, I use the original FX back piece, and use the base measurements, as well as the curve to help establish where the dome would sit. So the dome fits everything. Once I start the clay, I should be able to help "meld" the pieces together, so that it will all just flow with each other... I need sleep... [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification